Solution for shrinkage cavities in PCB board drilling

2019-01-15 Writer: H.C.C. Views: 497

  The reason for the shrinkage of holes in the PCB board drilling process is that the copper clad board is drilled in the PCB process. Due to the heat, the drilled holes shrink and the holes are smaller than the drill bit.

  The reason for the occurrence of shrinkage cavities is mainly that the substrate is not completely cured, and the subsequent processing of the PCB board is repeated by the heat generated holes, which is often encountered in the application of the insulating board. Since the shrinkage hole affects the assembly of the subsequent electronic components, it is necessary to prevent the substrate from being incompletely cured, resulting in a shrinkage phenomenon of the PCB process. After receiving complaints about quality problems from users, it can be solved by increasing the degree of curing of the substrate.

  Incomplete curing of the substrate may also cause oblique holes in the drilling process of the PCB board.

  Since the thickness of the copper clad laminate is relatively thin, the oblique hole is not easily observed, so the inclined hole mainly appears on a relatively thick insulating plate. During the drilling process, the drill bit does not pass vertically through the substrate, but obliquely through the substrate, seriously affecting product use. The cause is due to incomplete curing of the substrate.

  Basic curing is not the main problem that affects the hole in the PCB board drilling process. Although it seems to be a small problem, it will increase the difficulty of assembly of the PCB board, and the quality may be greatly discounted, so the basic curing is improved. Degree is very important!

Телефон +86 13715251970

QR-код WhatsApp WhatsApp

QR-код WeChat WeChat

Наверх Наверх


QR-код WeChat

Отсканируйте QR-код с помощью WeChat


QR-код WhatsApp

Отсканируйте QR-код с помощью WhatsApp


QR-код Viber

Отсканируйте QR-код с помощью Viber